Lucent Technologies Switch P333T Uživatelský manuál stáhnout pdf (Strana 27)

Chapter 4 Installation and Setup

Cajun P333T User’s Guide 17

Installing Expansion Sub-modules

Caution:

The expansion sub-modules contain components sensitive to electrostatic

discharge. Do not touch the circuit board unless instructed to do so.

Installing the Expansion Sub-module into the Cajun P330

1 Remove the blanking plate or other sub-module (if installed).

2 Insert the sub-module gently into the slot, ensuring that the Printed Circuit

Board (PCB) is aligned with the guide rails.

The PCB

not

the metal base plate fits into the guide rail.

3 Press the sub-module in firmly until it is completely inserted into the

Cajun P330.

4 Gently tighten the two screws on the front panel of the expansion sub-module

by turning the screws.

Removing an Existing Expansion Sub-module

1 Loosen the screws by turning the knobs.

2 Grasp the two knobs one near each side of the front panel, and pull gently but

firmly towards yourself.

3 Insert another expansion sub-module or the blanking plate.

Note:

The Cajun P330 switch must not be operated with the expansion slot open;

the expansion sub-module slot should be covered with the supplied blanking plate

if necessary.

Note:

Expansion sub-modules are hot swapable and can be inserted or removed in

an operating base unit.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 81 82

Žádné komentáře

Lucent Technologies Switch P333T Uživatelský manuál Strana 27