Lucent-technologies Network Access Module Uživatelský manuál stáhnout pdf (Strana 30)

Observe LED Behavior

3-6 INA Module Installation and Configuration Guide

After the module has been powered up and loading is complete, make sure that the LED

is blinking off once every 5 seconds. The INA module takes about 20 seconds to reach

this state.

Ethernet LEDs

These LEDs (Figure 3-8) show the status of the Ethernet connection to the INA module.

Figure 3-8 Ethernet LEDs

• The green link LED is on when the module has link integrity to a 10BaseT hub,

switch, or router. Make sure that this LED lights when a cable has been connected

between the module and an Ethernet hub. If the LED does not light, check the cable

itself and the network connections.

• The amber network activity led blinks to indicate Ethernet traffic. During heavy

traffic, this LED might appear solid due to its rapid blinking. Depending on your

network, you might not necessarily see much traffic.

network activity LED Amber

Green

Ethernet Link LED

1210-006

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 74 75

Žádné komentáře

Modèles	Type de document
24264	Fiche technique Imation BD-R 1-4X 25GB Single Layer, 2 pages
I26162	Fiche technique Imation BD-R, 8 pages

Lucent-technologies Network Access Module Uživatelský manuál Strana 30