Lucent-technologies Network Access Module Uživatelský manuál stáhnout pdf (Strana 58)

T1/PRI Cable

B-2 INA Module Installation and Configuration Guide

T1/PRI Cable

Table B-2 shows the pinouts for a category 5 unshielded, ungrounded, twisted pair

cable, as specified by the EIA/TIA-568-B wiring standard, with an RJ-48C connection

Ethernet Interface

Table B-3 provides specifications for the 10Mbps baseband IEEE 802.3-compatible

Ethernet interface.

Table B-2 T1/E1 RJ-48C Connector Pinout

T1 Port

RJ-48C Signal Definition

Direction to or

from the INA

Module

1 RXD (Ring) Receive Data Input

2RXD (Tip)

4 TXD (Ring) Transmit Data Output

5TXD (Tip)

Table B-3 Ethernet Interface

Ethernet

Type

Connector

Type Cable Type

Tra nsm ission

Distance

RJ-48C RJ-48C for 10BaseT Category 5

unshielded

twisted pair

Hub distance—328ft (100m) maximum

Repeaters—four maximum

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 74 75

Lucent Technologies 1
October 1999 1
7820-1000-001 1
Year 2000 Compliance 2
Copyright and Trademarks 3
Contents 5
Safety Instructions 9
About This Guide 11
PortMaster Documentation 13
Additional References 13
Document Conventions 14
Document Advisories 14
Technical Support 15
INA Module Training Courses 15
PortMaster Training Courses 15
Limited Warranty 15
INA Module 1 17
On the INA Module 18
INA Front Panel 18
1210-001 19
T1/PRI Provisioning 21
Assign T1/PRI Channels 22
Network Settings 22
Installing the INA Module 3 25
Set DIP Switches 26
Connect a Console (Optional) 27
Connect a T1/PRI Cable 27
Connect an Ethernet Cable 28
Observe LED Behavior 28
T1/PRI LEDs 28
System LED 29
Ethernet LEDs 30
Using the INAWizard 4 31
Run the Wizard 32
Connect a Console 33
Using the C0 Console Port 33
Using a Telnet Session 34
Set the Broadcast Address 35
Set the System Name 36
Configure the WAN Port 37
Set the Channel Rate 38
Set Up Additional WAN Ports 38
Set the Netmask 39
Set the Transport Protocol 39
Using PMVision 6 41
Using a Crossover Cable 42
Run PMVision 42
Selecting PMVision Functions 44
Using Configuration Functions 44
Enter Basic Settings 45
Troubleshooting A 49
Observing Boot Messages 50
Using the DS-1 Test Jacks 53
Cable Specifications B 57
T1/PRI Cable 58
Ethernet Interface 58
Crossover Cable 59
DSU Channel Selection 62
Error Events 63
24 Hour Event Totals 64
Current Events 65
Selected Interval Events 65
Clearing Error Events 65
Demand Tests 66
Backup and Restore 67
Surrogate Operation 67
Board Renumbering 68
Print Reports 68
Other System Interactions 68
Numerics 71

Komentáře k této Příručce

Žádné komentáře

Lucent-technologies Network Access Module Uživatelský manuál Strana 58

Komentáře k této Příručce

Související produkty a manuály pro Hardware Lucent-technologies Network Access Module